ZONESUN 16-19mm Pneumatic Steel Strap Strapping Machine

Parameter:

Air pressure: 0.4-0.6Mpa

Tape size: (16-19)x(0.63-0.9)mm

Tensioning force: 3000N

Feature:

Light weight ,easy operation, safety and reliable ,excellent performance and so on.

All actions of tensioning ,sealing and breaking can be finished with one hand.

It is widely used in every kind of bundling of steel and non-ferrous metal materials.

Notice

It must adjust the air pressure within the range of 0.4MPa to 0.6MPa to obtain enough air pressure,otherwise, it will effect the working performance.

Be careful the interval between feed wheel and rolling plate teeth should be within 0.1-0.3mm,otherwise, it need be adjusted. 

Air compressor required,Sold separately

HIGH POWER CYLINDER

Automatic tensioning, locking, cutting, and tightening.

HIGH QUALITY MOTOR

Easy to bundle, suitable for all kinds of items.

AIR PUMP CONNECTOR

Use high quality alloy material pipe joint.

HIGH QUALITY RUBBER TRACHEA

With alloy joints, high efficiency and wear resistance.

EASY TO OPERATE

Insert the strap into the machine and press the tension switch until the strap is tightened. Press the lock switch until the latch is closed.

LOCK CLIP

High-quality steel material, high hardness, high tensile strength.

ALLOY CUTTER

Made of high quality metal, high hardness, wear resistance and long service life.

(1) PACKING STRAPS

The lock is placed on the steel strip for the strapping machine, and the steel strip is inserted around the object one week and then inserted into the lock to form the upper and lower steel strips, and finally the lower steel strip is folded about 50 mm away from the lock.

(2) OPEN THE SWITCH

Open the air source switch, place the strapping machine on top of the object to be bundled, bring the upper layer of steel under the stretching roller, and push the strapping machine forward to make the position of the locking buckle and the locking mechanism match. At this time, the strapping machine Preparation is complete.

(3) TIGHTEN THE STRAP

Press the tension switch down and the tension roller presses the steel strip to start working. After the steel strip is tightened, the air motor stops.

If the tensioning process has to be interrupted, press the clamp to the left.

(4) SEALING TAPE

Press the lock switch again to lock and cut off. At this point, the operation is over and the engine can be lifted out of the machine.

(5) RELEASE THE HANDLE

By adjusting the screw 118, the tightening force of the strapping machine can be adjusted, and the screw is adjusted clockwise to increase the flow rate of the compressed air and increase the tightening force.